We had this brand-new Lotus Emira in the studio for full-body Paint Protection Film. The goal was simple, lock in that flawless factory gloss and give this exotic the long-term protection.
Vehicle: Lotus Emira (Yellow)
Project Type: Full-Body Paint Protection Film Installation
Goal: Preserve factory gloss, defend against rock chips, and maintain a flawless showroom finish
Installer Team: Prestige Protective Films
Service Location: Waterford, Michigan
Project Area: Greater Detroit Region | Oakland County
The Lotus Emira showed up at Prestige Protective Films brand new, and the owner wanted to preserve that perfect finish from day one with full-body protection. With its low stance, aggressive lines, and lightweight construction, the Emira’s paint is more vulnerable than most drivers realize, especially on Michigan’s unpredictable roads.
Even short drives around Waterford can expose an exotic like this to rock chips, grit, and surface wear. The Emira’s sculpted panels and sharp aero details also make it more likely to catch debris in places that are hard to repair later. Protecting the entire vehicle with PPF ensures the paint stays as flawless as it was the moment it arrived.
For a car as special as the Emira, the goal was simple: keep the factory gloss untouched, minimize long-term maintenance, and give the owner complete peace of mind every time he takes it out on the road.
This project focused on giving the Lotus Emira complete exterior protection from day one. Our team installed full-body Paint Protection Film to preserve the factory gloss, defend against rock chips, and maintain a flawless finish on Michigan roads.
These steps ensured the film bonded cleanly, maintained a smooth finish, and delivered the long-term protection the owner wanted for this brand-new Emira.
Just like every exotic that enters Prestige Protective Films, we started this Lotus Emira with a full decontamination wash to prepare it properly for paint protection film. The car may have been brand new, but Michigan transport dust, pollen, and surface contaminants still needed to be removed.
We began by cleaning the wheels, using an acid-free wheel cleaner and soft brushes to avoid scratching the rotor hats or delicate finishes. Then we blanketed the Emira in thick foam to break down surface grime before going into a safe, two-bucket contact wash.
Once rinsed, we performed both chemical and physical decontamination, first using an iron remover to dissolve embedded particles, then clay barring the surface to eliminate anything bonded to the clear coat. A touchless air dryer finished the step, ensuring no towel marks before entering our PPF bay.
Inside our controlled bay, we inspected the Emira’s paint under high-output LED correction lights. Even factory-fresh paint can show micro-swirl marks, light transport defects, and minor inconsistencies, especially on exotic panels with dramatic curves.
We performed a light refinement using a dual-action polisher, a finishing pad, and a fine polish. This created a smooth, uniform foundation for the PPF. On bright colors like this yellow, even the smallest imperfection would be visible once the film was applied, so attention to detail here was essential.
With the finish dialed in, we began installing Paint Protection Film across the Emira’s entire exterior. The Emira’s body presents unique challenges, sharp aero edges, deep vents, swooping curves, and tight tolerances, so each panel required patient, precise handling.
Using a slip solution, controlled heat, and soft squeegee blades, we aligned, stretched, and anchored the film without introducing texture or distortion. Every corner and edge was wrapped or tucked for 99% coverage, leaving clean seams and a factory-level appearance. Once applied, the film immediately enhanced the gloss and depth, giving the Emira that “wet” exotic-car look that stays protected during real-world driving.
After the installation, the film needs time to settle and fully bond. We left the Emira in our temperature-controlled bay so moisture could evaporate naturally from beneath the film. Once the initial curing began, we inspected every panel under multiple lighting temperatures, LED, natural white, and warm shop lighting, to check for tension points, alignment, wrapped edges, and any tiny imperfections that only reveal themselves under specific angles. This step is crucial for exotic PPF installations, where panel complexity demands extra care.
When the PPF had set, we performed a full detail using PPF-safe sprays, plush microfiber towels, and soft-edged tools to ensure no scratching or marking. We cleaned the glass, checked all seams again, and wiped down the bodywork until the finish looked perfect from every angle.
Stepping back, the transformation was obvious, the Emira’s paint now had a flawless, glossy, and deeply protected appearance ready for any Michigan road. The owner received a car that looked brand new but was now equipped with protection designed for real-world driving.
Once the full-body PPF settled and the final checks were complete, the Lotus Emira looked exactly the way a brand-new exotic should, deep gloss, crisp reflections, and perfectly protected curves from nose to tail. The film blended cleanly into every panel, enhancing the yellow finish without changing the character of the car.
With all seams tucked, edges wrapped, and the film fully bonded, the Emira left our Waterford studio with a smooth, consistent finish ready for real Michigan driving. The owner now has the confidence to enjoy the car without worrying about rock chips, road debris, or early paint wear, just the thrill of a protected, flawless exotic.
https://www.instagram.com/p/C8-dGd1ODu8/?utm_source=ig_web_copy_link&igsh=MzRlODBiNWFlZA
Exotic cars like the Lotus Emira require a steady hand and a deep understanding of complex bodywork. Our team works with high-performance models every week, giving us the precision and confidence needed for full-body PPF on vehicles with intricate curves and aero features.
Every product we use, from our slip solutions to our squeegee systems, is selected to protect delicate finishes and ensure long-term clarity. We rely on top-tier films, controlled installation environments, and refined techniques developed through years of hands-on work.
Local drivers, collectors, and first-time exotic owners come to us for one reason: consistency. They know their vehicles leave our studio with clean edges, uniform coverage, and protection that holds up against Michigan’s real driving conditions.
We treat every vehicle like it is our own. From the moment the Emira rolled into our bay, the focus was clear. Understand the owner’s goals, explain the process, and deliver a finish that feels as good as it looks. That level of care is what keeps clients coming back.
Pricing for a full-body PPF installation on a Lotus Emira can vary depending on the condition of the paint, the complexity of the panels, and the level of coverage the owner chooses. At Prestige Protective Films, every exotic is evaluated individually to make sure the protection matches the vehicle’s needs and how it will be driven in Michigan.
Key factors that influence project pricing include:
Each quote is based on the car’s actual condition and the owner’s protection goals, ensuring the results are both durable and worth the investment.
Give your vehicle the same level of care this Lotus Emira received. Our team delivers clean installs, precise workmanship, and protection built to handle real Michigan driving conditions. Contact Prestige Protective Films to schedule your full PPF service and keep your exotic looking flawless for years to come.
